RAMPS 1.4 shield 3D Printer Kit In Pakistan

515-s239

New product

RAMPS 1.4 shield 3D Printer Kit In Pakistan

Ramps is short for reprap Arduino mega pololu shield, it is mainly designed for the purpose of using pololu stepper driven board (similar to 4988 driven board). Ramps can only work when connected to its mother board Mega 2560 and 4988/DRV8825. Owning to its stability in operation and great compatibility with most 3Dprinter (all reprap-model such as pursa i2 and i3). The combination of Ramps1.4+MEGA2560+A4988/DRV8825 is becoming a mainstream of DIY 3D printer control board.

More details

Warning: Last items in stock!

₨ 650

Add to wishlist

More info

Sepcification
 
Brand new and high quality
Fully assembled & tested,no soldering required
It is designed to fit for entire electronics needed a Reparap in one small package for low cost
The module design includes plug in stepper drivers and extruder control electronics on an Arduino Mega shield for easy service,part replacement,upgrade-ability and expansion
 
A number of Arduino expansion boards can be added to the system as long as the main Ramps board is kept to the top of the stack.
 
 
Features
 
1. Standard interfaces (as that of extruder)
 
2. Reserved GCI like I2C and RS232
 
3 MOSFET 3 MOSFET are applied to the heater/ fan and thermistor circuit.
 
4. Adding another 5A to protect the component parts.
 
5. An 11A fuse is added to the hotbed
 
6. Support 5 stepper drive board
 
7. The adoption of Pin Header as pololu makes it more convenient to repair or change.
 
8. I2C and SPI are reserved for expanding
 
9. All the MOSFET can be controlled by PWM
 
10. Use the interface of servo motor to adjust the level of printing platform automatically.
 
11. Adding a SD module for SD ramps module.
 
12. LED can indicate the status of the heater (the open and close of MOS).
  
13. 2 stepper motor for Z axis in parallel.
Image result for ramps 1.4
Related image
 
 

Reviews

No customer reviews for the moment.

Write a review

RAMPS 1.4 shield 3D Printer Kit In Pakistan

RAMPS 1.4 shield 3D Printer Kit In Pakistan

RAMPS 1.4 shield 3D Printer Kit In Pakistan

Ramps is short for reprap Arduino mega pololu shield, it is mainly designed for the purpose of using pololu stepper driven board (similar to 4988 driven board). Ramps can only work when connected to its mother board Mega 2560 and 4988/DRV8825. Owning to its stability in operation and great compatibility with most 3Dprinter (all reprap-model such as pursa i2 and i3). The combination of Ramps1.4+MEGA2560+A4988/DRV8825 is becoming a mainstream of DIY 3D printer control board.